360 T I 220 24

Home /360 T I 220 24

Model:360 T I 220 24

FEATURES
  • Natural air Cooling.
  • Shock & Vibration tested.
  • 200VDC input / Triple output.
  • Fast transients & lightning protection.
  • Over-voltage/short-circuit/over-current protected.
  • Rugged DC/DC Converter for Railway applications.
360 T I 220 24
SPECIFICATIONS
Input
Voltage 200VDC (180 - 220VDC).
Current 2.2Amp max at 200VDC.
Protections Lightning, Fast Transient, Surge & Burst.
Over current protection by fuse. Reverse polarity by active Diode.
Isolation
Input-Output 1500VAC 50Hz 1minute cutoff current 10mA.
Input-Case 1500VAC 50Hz 1minute cutoff current 10mA.
Output-Case 500VAC 50Hz 1minute cutoff current 10mA.
Environmental
Operating Temperature -40°C to +85°C (Monitoring on Heat sink)
Relative Humidity 20-90%RH (Non-Condensing)
Cooling Natural air Cooling
Output
Parameter O/P-1 O/P-2 O/P-3
Voltage +15VDC±2% -15VDC±2% 15VDC±2%
Current 8A 8A 8A
Power 120W 120W 120W
Ripple & Noise (mVp-p) at 20MHz & 1uf cer cap. 200 max. 200 max. 200 max.
Output Performance
Total Power 360W approx.
Output Stability (ΣUin + Iout + T ambient) <±3% of Vnom.
Dynamic regulation offset (Io=40/90%) <2% of Vnom.
LED Indications Green Bar Display for Input, Output & Red for Fault.
Efficiency >85% with 220VDC input & output full load
Hold ON time 20mSec or higher
MTBF 80,000Hrs
Protections
Output Protection Any output over voltage, under voltage & Over load/short ckt. In case of above condition occurance all outputs shall go shut down. Recovery manual after fault removal.
Over Temperature Derating > 95°C
PFC Contacts C,NC,No contact for any failure.
Common Return Two common return G-1 for Output-1,2, & G-2 for Output-3
STANDARDS CONFORMS
Vibration & Shock IEC61373, Class B, Category-1 body mount
Burst Immunity IEC61000-4-4
Surge Immunity IEC61000-4-5
Burn in Test 80 Hrs.as per temperature cycle shown in Annexure A Spec sheet-4452471-rev-3(BHEL)
Mechanical
Mounting Backplane Mounting
Connectors Molex Connector
Depth 323±1mm
Width 250±1mm
Height 65.5±1mm
Weight 2.8Kg (Without pack)
Note

Our Power Supply can cater to 180V - 360VDC Wide Input range. But Specifically for BHEL we have included Input window (180V - 220VDC).

Connector Detail for Wiring
Connector Part No. / Molex make
W1 76829-0002
W2 28-29-9088
W4 76829-0008
W3, W5, W6, W7 39-28-9048
PDUKE New Products Synqor Products Cosel Products