150 S I-28(BP)
Home /150 S I-28(BP)
- B-112, Block B, Phase-2, Noida, Uttar Pradesh-201305
- Phone No. : 0120-4693000
- Email. : sales@powertecsupplies.com
Home /150 S I-28(BP)
| Voltage | 230VAC ±10% 1Ø 50Hz |
| Current | 0.45A max during charging. |
| Isolation |
Input-Output : 500VDC 25Mῼ Input-Case : 500VDC 25Mῼ Output-Case: 500VDC 25Mῼ |
| Protections | Surge, Burst, Lightning & Fast Transients. |
| Voltage | 28VDC |
| Power capaacity | 5.0AH |
| Battery Charging time | 3Hrs max @ current 2.2Amp. |
| Charging mode | Constant current mode |
| Charging Temperature | -10°C to +55°C. |
| Cooling | Convection Natural Air Cooling |
| Relative Humidity | 20-90% RH (Non-Condensing). |
| Parameter | Specification |
|---|---|
| Voltage | 28VDC |
| Voltage setting | ±0.5% |
| Current | 1.5Amp |
| Ripple & Noise | ≤1% of vnominal at 20MHz band width with 1uf ceramic at RF probe. |
| Back-up time | 2.0Hrs |
| 8*2 LCD Display continious monitoring Battery Voltage , Battery drain current & % of Battery back-up balance. |
| On/Off control | Output & Display on/off control by switch. |
| Over-charge protection | Protected. |
| Over-discharge protection | Protected. |
| Short-circuit protection | Protected. |
| To avoid deep discharge the Battery must be charged every 40Days. |
| Vibration | 10 - 55Hz, 19.6m/s2 (2G). |
| Safety standards | Conformance to UL60950-1 |
| Mounting | Portable /Table top |
| Depth | 220mm |
| Height | 120mm with out handle |
| Width | 90mm |
| Weight (unpacked) | 3.5Kg |
| Input | Radial 3 Pin male |
| Output | Radial 3 Pin Female & D-Sub-9 Female. Both O/P connector are parallel |
| Mating Connector | Mating connector under vendor scope |
| Input Harness | 1Mtr Legth with one end mating female other end 5A Top. |
